The Digium TE207P offers an on-board DSP-based echo cancellation module. It supports E1, T1, and J1 environments and is selectable on a per-card or per-port basis.
Digium has designed the TE207P to be fully compatible with existing software applications and it is fully integrated with the Asterisk Open Source PBX/IVR platform. Also, the open source driver supports an API interface for custom application development. With the combination of Digium Hardware and Asterisk software, numerous combinations of telephony configurations are possible. From the traditional PBX to VoIP Gateways, Digium solutions are paving the way for a new generation of worldwide communications.
The TE207P supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported, also included are advanced call features. The TE207P is for use only with a 5.0 volt PCI slot.
- Digium TE207P Dual-Span Digital Board with an on-board DSP-based echo cancellation module.
- Supports E1, T1, and J1 environments and is selectable on a per-card or per-port basis. (32-bit, 5.0 volt PCI only).
- Identical to the TE205P except that it comes with the VPM450M Octasic DSP-based echo cancellation module.
- TE207P is for use only with a 5.0 volt PCI slot.
- Data Modes:
- Cisco HDLC
- HDLC
- PPP
- Multi-Link PPP
- Frame Relay
- Voice Modes:
- PRI CPE & PRI NET
- NI1
- NI2
- EuroISDN
- 4ESS (AT&T)
- 5ESS (Lucent)
- DMS100
- E&M
- Wink
- Feature Group B
- Feature Group D
- FXO & FXS
- Ground Start
- Loop Start
- Loop Start with Disconnect Detect
Safety Certification and Agency Approvals
Safety:
UL 60950-1:2003, First Edition CSA C22.2 No. 60950-1-03 1st Ed. April 1, 2003 IEC 60950-1:2001 First Edition EN 60950 AS/NZS 60950
Note: Finland, Norway and Sweden require that equipment using this product must be located in a Restricted Access Location (RAL).
Telecom:
FCC Part 68, ANSI/ITA-968-A, Including Amendment A1 and A2 Industry Canada CS-03 AS/ACIF S016: 2001 AS/ACIF S038: 2001
RosTest TBR4 November 1995 as amended by TBR4/A1 December 1997 TBR12 December 1993 TBR13 January 1996
Emissions:
Note: Shielded T1/E1/J1 cables are required for compliance purposes.
47 CFR Part 15, Subpart B / 47 CFR Part 15, Subpart B, Class B EN 55022:1998 Class B / EN 55022:1998 Class B Radiated and Conducted EN 55024:1998 / IEC 61000
